Cavaliere AP238-PS85-42 Manuel d'instructions

500 W Warner, Santa Ana CA 92707Technical Support: 714-622-1550cavalierehoods.comInstallation Manual

IMPORTANT: Observe all governing codes and ordinances. (Please consult with a qualied electrician for 220-Volt 50 Hz voltage)It is the customer’s res

PreparationPage 9Advanced Preparations:Be familiar with the controls of the range hood by reading • through Range Hood Operations, Page 12.Place the r

Page 10InstallationFigure 5Figure 6Figure 4Installations (refer to Page 4 for parts):Measure the distance between stove top and the bottom of range ho

Page 11Installation (Continued)Figure 9Figure 8Figure 7Figure 10Store excess wires in the wiring box.5. OPTIONAL: If you purchased a single-piece chim

Page 12Range Hood OperationsControl Panel Layout and Buttons Congurations:In addition to the remote control feature, this range hood is also equipped

Page 13Range Hood Operations (Continued)Control Panel Layout and Buttons Congurations:Activating Light Function: • Press Light button once to turn

TroubleshootingPage 14If the range hood or halogen light does not operate 1. after installation:Check if the range hood has been plugged in, make • su

Use and Care InformationOperations:Read and understand all instructions and warnings in this manual before operating the appliance. Save these • instr

Measurements and DiagramsAll measurements in parenthesis are in millimeter.• All inch measurements are converted from millimeters, thus inch measureme

All measurements in parenthesis are in millimeter.• All inch measurements are converted from millimeters, thus inch measurements are estimated.• AP238

Page 18All measurements in parenthesis are in millimeter.• All inch measurements are converted from millimeters, thus inch measurements are estimated.

Rear Knockout Holes:All measurements in parenthesis are in millimeter.• All inch measurements are converted from millimeters, thus inch measurements a

Page 20Circuit Diagram:

Range Hood Assembly:Page 21No. Description Quantity1 Hood Body 12 Light 23 Control Panel 1 4 Oil Tunnel 15 Blower Assembly (Motor, Fan Blade, Protecti

Page 22Blower Assembly:No. Description No. Description4.1 Air Chamber 4.5 Motor4.2 Air Flow Grill 4.6 Right Squirrel Cage4.3 Left Locknut 4.7 Right Lo

Page 23WARNINGHazard of Burns!Light bulb become extremely hot when turned on. DO NOT touch bulb until switched off and cooled. Touching

Page 24One Year Parts Warranty:For one year from the date of original purchase, your local reseller will provide free of charge, non-consumable replac

Page 25Carefully inspect all items for damages before accepting delivery. note any damages on the freight bill or express receipt. request name and si

500 W Warner, Santa Ana CA 92707Technical Support: 714-622-1550cavalierehoods.com

Important Safety NoticeRead all Instructions before Installing and operating this applianceThe installation in this manual is intended for qualied in

Page 2Important Safety NoticeRead all Instructions before Installing and operating this applianceWARNINGYour safety and the safety of others is very i

Table of ContentsINSTALLATIONTools needed...3Parts supplied...

Page 4Parts supplied:Grease TunnelQty: 4 PCS(For sheet rock only)Qty: 4 PCSQty: 8 PCSHood-mounting Bracket (Qty: 2PCS)(Optional)Ducting TransitionQty:

Ceiling HeightVenting RequirementsPage 5Height & ClearanceUnder Cabinet Range hood36” Counter TopMin: 27” Max: 30”Vent system must terminate

Page 6IMPORTANT:A minimum of 8” round (standard for this range hood) or 3-1/4 x 10” rectangular duct (purchased separate-• ly) must be used to maintai

Venting MethodsPage 7This range hood is factory set for venting through the roof or wall.• Vent work can terminate either through the roof or wall. To